System Timeout - Xerox WorkCentre 5755 System Administrator Manual

System Timeout

This feature resets the system to the default state after a set amount of time elapses without any user
interface activity.
If users do not interact with Internet Services web pages within the time defined, logged in users will
be logged and all unsaved settings will be lost.
When Authentication and/or Accounting is on (a user is logged in) and the System Timeout timer
expires and if no partial job exists, the system shall log the user out (without warning or notification)
and perform a Reset to Default.
At Your Workcentre:
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to
1. From the Properties tab, click on the [Security] link.
2. Select [System Timeout] in the directory tree.
3. The System Timeout page displays. In the Web System Timer area, for [Minutes], enter the time
the system will wait before a logged in user will be logged out. You can enter a time from six to
60000 minutes.
4. Click on the [Apply] button.
5. Click on the [OK] button when you see the message "Properties have been successfully
modified".
Access Internet Services as System Administrator
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
on page 16.
System Administrator Guide
Security
181