Using Ntp - Xerox WorkCentre 5755 System Administrator Manual

General Setup
b. Touch the Left and Right arrow, select the required value for the following:
• Day (dd) - the range will be dependant on the selected month.
• Month (mm) - the range is from 1 to 12.
• Year (yy) - the range is from 00 to 40.
6. Select the [Time] tab.
a. Select one of the following time format:
• AM
• PM
• 24 Hour
b. Touch the Left and Right arrow, select the required value for the following:
• Hours - for a 12 hour format the range is 1 to 12 and for a 24 hour format the range is 0
to 23.
• Minutes - the range is 00 to 59.
• If the 12 hour format is selected, select either [AM] or [PM] from the drop-down menu.
Note: Any changes to these settings will require the device to reboot.
7. Select the [GMT Offset (Time Zone)].
a. Touch the Left and Right arrows, selecting the required time zone.
8. Touch [Reboot], the system will reboot.

Using NTP

NTP (Network Time Protocol) is designed to synchronize the clocks of computers over a network. This
feature will ensure that the device's internal clock stays synchronized with the NTP server you specify.
If you set up using NTP, the date and time of the system can be set using a network time
Note:
server (NTP). The system will check the server at boot time, every subsequent 24 hours, and any
time the NTP parameters are modified.
If the device is configured to use DHCP, and an NTP server, or the GMT offset is provided by the
DHCP server, then the data entered here will be overwritten by the corresponding DHCP retrieved
items. Enabling NTP or modifying NTP settings will cause a system reset.
At Your Workstation:
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to
1. From the Properties tab, click on the [Connectivity] link.
2. Click on the [Protocols] link.
3. Select [NTP] in the directory tree.
4. In the Offset of Local Time Zone area select the time offset (in hours) from the [Offset of
Greenwich Mean Time] drop-down menu. The default is 0.0.
5. In the Network Time Protocol area:
a. For NTP Enabled, check the [Enabled] checkbox to enable NTP on the device.
b. Select one of the following:
26 Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
Access Internet Services as System Administrator on page 16.