Quick Setup - Xerox WorkCentre 5755 System Administrator Manual

Device Connection and Quick Setup
Settings, to enable the use of the device web user interface for network and options configuration. If
necessary, reset TCP/IP Addressing (including DHCP and DNS settings) and enable HTTP as follows:
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to
1. From the Tools pathway, touch [Network Settings].
2. Touch the [Network Setup] button,
3. Touch [TCP IP].
4. From the TCP/IP screen, touch [HTTP/IPP Enablement].
a. For Protocol touch [Enable].
b. Touch [Save], to return to the TCP/IP screen.
5. Touch [TCP/IP Settings].
6. Configure TCP/IP settings, including DHCP (Dynamic Addressing) and DNS, touch [Save], touch
the [Close] button to return to the Network Setting screen.
Note: This device supports IPv6 Addressing, with an automatically-built Link Local Address for
broadcasting to routers that can supply the network-layer configuration parameters. See
Configure Network Connectivity Protocols with Internet Services

Quick Setup

When your device is configured with an IP Address and HTTP is enabled, you can configure network
information from your web browser via Internet Services. Enter the IP Address of the device in your web
browser to access Internet Services. For further information, refer to
12 Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
Access Tools Pathway as a System Administrator on page 10.
on page 17.
Internet Services on page 13.