Exposure (Standard Adjustment); User Authentication, And/Or Via Fax Server Function Confirmation - Panasonic DP-8020E Service Manual

7.3.6. Exposure (Standard Adjustment)

Caution:
Before making any adjustments, confirm that the following contents (F6-17, 18, and 19) are set to "0".
DO NOT adjust these settings in the field.
F6-17 : Grid Voltage compensation
F6-18 : Standard Laser Power compensation
F6-19 : Std Bias DC Voltage compensation
Note:
If an exposure adjustment is required during a routine service call, ensure the developer unit is
properly toned before making any adjustments.
1. Press "Function", "Original Size", and "3" keys sequentially to enter the Service Mode.
2. Press the "2", and the "Start" keys to enter the F2 Mode (Single Copy Test).
3. Set the exposure to the center position.
4. Set the machine to TEXT / PHOTO Mode.
5. Make a copy of Test Chart 53/54 with gray scale (P/N: FQ-SJ1011), and compare the density to the
chart shown below. If it is within specification, skip to step (14).
a. Gray scale "A" should not be visible.
b. Gray scale "2" should be clearly visible.
. .
.
.
.
.
.
.
.
. .
.
.
.
. .
.
6. Press the "Stop" key to exit the F2 Mode (Single Copy Test).
7. Press the "6", and the "Start" keys to enter the F6 Mode (Adjust Parameters).
8. Enter F6-50 Mode (T/P Mode Image Density).
9. Press the "Set" key to highlight the current value.
10. Enter a new value (up to 3-digits).
Note:
The "Reset" key is used to change to a Negative, or Positive (+/-) value.
(+) : Lighter
(-) : Darker
11. Press the "Set", and "Stop" keys.
12. Enter F2 Mode (Single Copy Test).
13. Make a copy to confirm the adjustment.
Note:
Repeat Steps (3) to (10) until the desired density is attained.
F6-49 : T Mode Image Density (Text)
F6-51 : P Mode Image Density (Photo)
14. Press "Function", and "Clear" keys simultaneously to exit the Service Mode.

7.3.7. User Authentication, and/or Via Fax Server Function Confirmation

(
Specified Destinations only
If your customer requires User Authentication, and/or Via Fax Server, setup the feature(s) by referring to the
Operating Instructions (For User Authentication).
Ver. 1.0
A
Not visible
.
1 (Not visible, or hardly visible)
. .
2 Clearly visible
3
)
329
DP-8020E/8020P/8016P
SEP 2006