Unit Information Of The Firmware Update Mode - Panasonic DP-8020E Service Manual

Unit information of the Firmware Update Mode:

For USB Connected Unit (DP-2310/3010):
Every time the machine finishes receiving a firmware code file, the unit does the delete and
rewrite of the firmware code and will return to Service Mode again. Set the unit back to
USB Firmware Update after the machine returns to Service Mode and continue the
firmware update.
When the last firmware code file (PNL) is received, the unit will re-boot automatically and return
to standby. The unit doesn't re-boot automatically when you select an independent file and the
PNL firmware wasn't transferred. Cycle the power Off-On and reset the unit if the firmware code
file transfer is finished and the unit has returned to the Service Mode.
For USB Connected Unit (Other models):
Every time the machine finishes receiving a firmware code file, the unit does the delete and
rewrite of the firmware code and will return to USB Firmware Update and continue the
firmware update automatically.
When the last firmware code file (AutoBoot) is received, the unit will re-boot automatically and
return to standby. The unit doesn't boot automatically when you select an independent file. (The
display returns to "Update in Progress") Cycle the power Off-On to reset the unit if the firmware
code file transfer is finished and the display shows Completed.
For Parallel Connected Unit:
Every time the machine finishes receiving a firmware code file, the unit does the delete, rewrite
of the firmware code and then boot. Set the unit back to Parallel Firmware Update in Service
Mode after boot up, to continue the firmware update.
8
When the transfers of all the firmware files are
finished, click [Finish] to close the tool.
Note: For USB Connected Unit only.
When the unit returns to standby, Plug
and Play of the printer will popup.
Click [Cancel] to close the Printer Plug
and Play window.
Local Firmware Update Tool (Parallel/USB Port)
Page 15