Panasonic DP-8020E Service Manual page 279

No. Parameter
069 NYSE Local Print
(USA, and
Canada Only)
070 Line Error
071 Total Error
072 Continuous Error 1 = Off (unlimited)
073 Error Detect
074 RTN Receive
075 Coding
076 Batch TX
(USA, and
Canada Only)
077 RX JAM Length
078~ Not Used
079
080 Doc Top Feed
081 Doc End Feed
082 JAM Length
083 Not Used
084 Line As No Paper 1 = Ring (ring)
085 Not Used
Ver. 1.0
Function Parameter Table
Selections
1 = Inc
2 = On (Always)
128 lines
256 lines
512 lines
1024 line
2048 lines
Off
(will not disconnect line)
1 = 5%
2 = 10%
3 = 15%
4 = 20%
2 = 3 lines/STD
3 = 6 lines/STD
4 = 12 lines/STD
1 = Lines
2 = Rate
1 = Disconnect
2 = Continue
1 = MH (MH only)
2 = MR (MH, or MR)
3 = MMR
(MH, or MR, or MMR)
4 = JBIG
1 = Off
2 = On
1 = Off (unlimited)
2 = 2 m
-99
~
+99
-90
~
+127
1 = 1 m
2 = 2 m
2 = Busy (keep line busy)
Selects the printing condition for the incoming faxes
after FAX Forwarding.
INC. : Prints only if FAX Forwarding fails.
ON : Always prints.
1. Selects the line disconnect condition during
reception. If the number of line errors exceed this
setting, the unit will disconnect the line.
Press "V", or "/\ " to select the symbol rate.
2. Selects the transmit condition of RTP/PIP, or
RTN/PIN.
(Available if No. 73 Error Detect is set to
"LINES") (See Note 1)
Selects the transmit condition of RTP/PIP, or RTN/
PIN.
(Available if No. 73 Error Detect is set to "RATE".)
(See Note 2)
Selects the continuous total error criteria of Off/3/6,
or 12 lines in Standard mode. If continuous total
error exceeds this setting, the unit will transmit
RTN/PIN.
(Available if No. 73 Error Detect is set to "RATE".)
Selects the error detect condition Lines/Rate.
Selects whether to disconnect the phone line, or
continue when "RTN" is received.
Selects the coding scheme.
Selects whether the batch transmission is available.
Selects the maximum length of a received
document that can be printed.
Adjusts the distance between the scanning sensor
ON position, and the scanning start position.
Adjusts the distance between the scanning sensor
OFF position, and the scanning end position.
Selects the maximum length of the original that can
be scanned.
Selects whether to ring, or send a busy tone to the
remote station when the recording paper runs out,
or the unit cannot receive because of any trouble.
279
DP-8020E/8020P/8016P
Function
SEP 2006