How To Turn Off The Power; Important Notice - Panasonic DP-8020E Service Manual

Important Notice

Please read these Instructions completely BEFORE installing any optional
accessories. Installing the additional board, or connector with the power ON
(only the power switch OFF) could damage the SPC, and/or SC board.
If the Hard Disk Drive Unit is installed, to prevent a Disk Scan Function from
being performed (similar to when the power is abruptly interrupted to the PC),
it is important to follow the step sequence below when turning OFF the Power
Switch on the machine.

How to turn OFF the Power:

1. If the machine is in the "ENERGY SAVER
(Shutdown Mode)", you may turn the
Power Switch on the machine to the
OFF position. If it is not in the "ENERGY
SAVER (Shutdown Mode)", continue to
step 2 below.
2. Press "FUNCTION" and "ENERGY SAVER"
keys simultaneously first.
3. Wait approximately 10 seconds while
the machine writes the closing status onto
the Hard Disk Drive Unit, and advances into
"ENERGY SAVER MODE".
4. Turn the Power Switch on the machine to the OFF position.
5. Disconnect the Telephone Line Cable, if the Fax Option
is installed.
Unplug the AC Power Cord.
6.
(When the Fax option is installed, there is a remote possibility of electrocution when
servicing the unit during a Lightning Storm. As a precaution, disconnect the Telephone
Line Cable first, before unplugging the AC Power Cord.
This service information is designed for experienced repair technicians only and is not intended for use
by the general public. It does not contain warnings or cautions to advise non-technical individuals of
potential dangers in attempting to service a product. Products powered by electricity should be serviced
or repaired only by experienced professional technicians. Any attempt to service or repair the product or
products dealt within this service information by anyone else could result in serious injury or death.
* The specifications are subject to change without notice. Panasonic Communications Co., Ltd. reserves
the right to make improvements in the product design without reservation, and without notice.
<Example : DP-8020>
WARNING
4