"Call For P/M"; "Call For P/M Adf"; Resetting The P/M (Preventive Maintenance) Counter; U14 "Replace The Toner Waste Container" - Panasonic DP-8020E Service Manual

3.5.

Resetting the P/M (Preventive Maintenance) Counter

When the machine reaches the preset P/M Cycle, it will show "Call for P/M", or "Replace The Toner Waste
Container" on the LCD Display. The PM Counter can be reset by following the procedures below.
3.5.1. "Call for P/M" (Default: 120K)
1. Perform the P/M (Preventive Maintenance). Refer to Section 3.3, and 3.4.
2. Press "FUNCTION", "ORIGINAL SIZE", and "3" keys sequentially to enter the Service Mode.
3. Enter the Copy Service Mode F5-70 (PM Cycle), and change to the desired value.
4. Press "FUNCTION", and "CLEAR" keys simultaneously to exit the Service Mode.
3.5.2. "Call for P/M ADF" (Default: Not Set)
1. Perform the P/M (Preventive Maintenance). Refer to Section 3.3, and 3.4.
2. Press "FUNCTION", "ORIGINAL SIZE", and "3" keys sequentially to enter the Service Mode.
3. Enter the Copy Service Mode F5-87 (ADF PM Cycle), and change to the desired value.
4. Press "FUNCTION", and "CLEAR" keys simultaneously to exit the Service Mode.
3.5.3.

U14 "Replace The Toner Waste Container"

A. Blinking Maintenance, and Toner Waste Container Indicators
Upon detecting that the Toner Waste Container is full, the machine will complete the current job, and
stop operating.
A blinking Maintenance, and Toner Waste Container Indicators will appear on the display.
To continue using the machine temporarily while waiting for the Service Technician, press any key
(up to 100 additional copies can be made).
B. Steady Maintenance, and Toner Waste Container Indicators
Upon reaching the 100 copies, the machine stops, and will not allow further operation until the Toner
Waste Container is replaced.
Replace the Toner Waste Container. (Refer to Section 2.2.5.)
Ver. 1.0
108
DP-8020E/8020P/8016P
SEP 2006