Ver. 1.0
(33) Attach the Type Approval Label (specified
destination) to the Rear Cover as illustrated.
Note: (For New Zealand only)
Attach the Type Approval Label and Telepermit
Label to the Right Side Cover as illustrated.
(34) Proceed with the installation of other options.
If finished, reinstall all Harnesses and Covers.
(35) Plug the AC Power Cord and turn the Power
Switch on the Right Side of the machine to the
ON position.
(36) Connect one end of the Telephone Line Cable
to the LINE Jack on the right side of the
machine, and the other end to the Telephone
Jack on the wall.
<Installing the Stamp Assembly for i-ADF>
(37) Lift the Original Tray Assembly.
(38) Lower the Inverting Guide 2 Assembly.
(39) Install the Stamp Assembly.
(40) Perform Service Mode F6 (No. 69) to adjust the
Stamp Position.
<Installing the Stamp Assembly for ADF>
(41) Open the ADF Unit.
(42) Detach the Hook and Loop Fastener on the left
side of the Scanning Pad.
344
DP-8020E/8020P/8016P
SEP 2006