Erasing The Master Firmware Card - Panasonic DP-8020E Service Manual

3. Turn the Power Switch on the Right Side of the machine to the ON position.
4. Press "FUNCTION", "ORIGINAL SIZE" keys, and then Key "3" on the keypad sequentially.
5. Perform the Update Program Card Mode F9-09 (Update Program Card).
The unit is now ready to accept the firmware code from the USB Port.
Now connect the USB Cable between the Unit, and PC.
(Refer to the Local Firmware Update Tool OI on the CD)
Repeat the above steps if there are additional master firmware cards to be programmed.
B. Copying the Firmware from an Existing Machine using a Flash Memory Card (4 MB, or 8 MB)
1. Turn the Power Switch on the Right side of the machine to the OFF position. (During a Lightning
Storm, to prevent electrocution disconnect the Telephone Line Cable first before unplugging the AC
Power Cord, if the Fax Option is installed.)
2. Install a Flash Memory Card (4 MB, or 8 MB) into the machine.
3. Turn the Power Switch on the Right Side of the machine to the ON position.
4. Press "FUNCTION", "ORIGINAL SIZE" keys, and then Key "3" on the keypad sequentially.
5. Perform the Copy Service Mode F9-08 (Program Backup).
6. The firmware is copied into the Flash Memory Card.
7. After the backup is completed, press "STOP" first, and then press "FUNCTION" + "CLEAR" keys
simultaneously to return to standby.
8. Turn the Power Switch on the Right side of the machine to the OFF position.
9. Remove the Master Firmware Card that you just created from the machine.
10. Turn the Power Switch on the Right Side of the machine to the ON position.
11. Use this Master Firmware Card to update the firmware on other machines.

3.2. Erasing the Master Firmware Card

1. Turn the Power Switch on the Right side of the machine to the OFF position. (During a Lightning
Storm, to prevent electrocution disconnect the Telephone Line Cable first before unplugging the AC
Power Cord, if the Fax Option is installed.)
2. Install the Master Firmware Card into the machine.
3. Turn the Power Switch on the Right Side of the machine to the ON position.
4. Press "FUNCTION", "ORIGINAL SIZE" keys, and then Key "3" on the keypad sequentially.
5. Perform the Service Mode F9-09 (Update Program Card).
6. After the Flash Memory Card is erased, machine prompts "READY TO PROGRAM PRESS SET TO
START". Press "STOP".
7. Press "STOP" first, and then press "FUNCTION" + "CLEAR" keys simultaneously to return to
standby.
8. Turn the Power Switch on the Right side of the machine to the OFF position.
9. Remove the blank Flash Memory Card from the machine.
10. Repeat from Step 2 above if you are erasing another Master Firmware Card.
4. User Authentication, and/or Via Fax Server Function Confirmation
(
Specified Destinations only
If your customer requires User Authentication, and/or Via Fax Server, setup the feature(s) by referring to the
Operating Instructions (For User Authentication).
Ver. 1.0
)
334
DP-8020E/8020P/8016P
SEP 2006