Sharp AR-BC260 Service Manual page 74

5) Remove the E-ring, the gear, and the bearing, and remove the
transport roller.
c. Transport section
<1> Vertical transport unit
1) Remove the drum and the developing unit.
2) Remove the front cabinet.
3) Remove the front frame cover.
4) Remove the multi manual paper feed unit.
5) Remove the rear cabinet, the connection right cabinet, the
rear right cabinet, the front right cabinet, and the right lower
cabinet.
6) Open the vertical transport guide. Remove the screw and
remove the vertical transport guide unit.
7) Remove the screw, and remove the vertical transport lower
unit.
AR-BC260 DESCRIPTIONS OF EACH SECTION 7 - 37
8) Remove the paper feed drive motor, and remove the connec-
tor on the rear side. Remove the screw, and shift the vertical
transport unit to the left to remove.
∗ When assembling, engage the four bosses indicated with
in the figure below.
<2> Transport roller 2
1) Remove the vertical transport unit.
2) Remove the screw, and remove the paper guide (A).
3) Remove the resin ring, and remove the pulley (B) from the
belt.
4) Remove the resin E-ring, slide the bearing (C), and remove
the transport roller 2 unit (D).
C
B
5) Remove the E-ring and parts, and remove the transport roll-
ers.
D
A