Sharp AR-BC260 Service Manual page 211

66 -33
Purpose Operation test/check
Function Used to detect signals (BUSY TONE/CNG/CED/
(Purpose) FNET) from the line. (When the FAX is installed.)
Section FAX
Item Operation
Operation/ Various signals are detected with the line
Procedure connected.
The detected signals are highlighted.
66 -34
Purpose Operation test/check
Function Used to display the time required for sending the
(Purpose) test image data. (When the FAX is installed.)
Section FAX
Item Operation
Operation/ The send test is executed, and the time to send the
Procedure image data in that test communication is measured
and displayed.
Send/receive are executed in the normal mode, and
the measure communication time (ms) is displayed.
66 -35
Purpose Setting
Function Used to rewrite the Modem program.
(Purpose) (When the FAX is installed.)
Section FAX
Item Data
Operation/ 1. Press the [EXECUTE] key. (YES/NO key
Procedure display)
2. Press [Yes] key to rewrite the Modem program.
(Press [NO] to cancel.)
3. Check sum is executed and the write result is
displayed.
(Check sum result display)
COMPLETE : Write complete
81 : Check sum error
82 : Write error
83 : Delete error
84 : Verify error
NG : Because of LOADER NG
66 -36
Purpose
Function
(Purpose)
Section
Item
Operation/
Procedure
66 -39
Purpose
Function
(Purpose)
Section
Item
Operation/
Procedure
66 -42
Purpose
Function
(Purpose)
Section
Writing
Item
Operation/
Procedure
1. Press the [EXECUTE] key. (YES/NO key display)
2. Press [Yes] key to rewrite the PIC program. (Press [NO] to
cancel.)
When reload is completed normally, "OK" is displayed. In case of
an error, "NG" is displayed.
AR-BC260 SIMULATION 9 - 73
Operation test/check
Used to check send/receive (data/command line)
from the Modem controller to the MFP controller.
(When the FAX is installed)
FAX
Operation
1. Press [EXECUTE] key to check send and receive
operation of the data line or the command line
individually from the Model controller to the MFP
controller.
Setting
Used to set the destination of the FAX.
(When the FAX is installed.)
FAX
Specifications
Press the key corresponding to the destination to set.
The set information is saved in the EEPROM in the
FAX unit.
If no setting is made, "NO DESTINATION" is
displayed.
Setting
PIC program rewriting (When the FAX is installed.)
FAX
Operation
Before executing this simulation, the WRITE
PROTECT jumper mounted on ICU PWB must be
changed.