Sharp AR-BC260 Service Manual page 159

14
14 -0
Purpose Clear/cancel (Trouble etc.)
Function Used to cancel self diag troubles H3, H4, and H5.
(Purpose) Inhibition of the color copy mode operation is
canceled.
Item Trouble
Operation/ 1. Press the [EXECUTE] key. (YES/NO key
Procedure display)
2. When YES key is pressed, the following troubles
are cleared. (Cancel with NO key.)
(Trouble codes to be canceled)
Target trouble
codes
H3-00 Heat roller high temperature detection (HL1)
H3-01 Heat roller high temperature detection (HL2)
H4-00 Heat roller low temperature detection (HL1)
H4-01 Heat roller low temperature detection (HL2)
H5-01 Five continuous detections of POD1 not-
reached jam
15
15 -0
Purpose Clear/cancel (Trouble etc.)
Function Self diag U6-09 (large capacity paper feed tray)
(Purpose) trouble cancel
Section Paper feed
Item Trouble
Operation/ Press the [EXECUTE] key to cancel the trouble.
∗
Procedure Press the [CLOSE] key to terminate the
simulation.
16
16 -0
Purpose Clear/cancel (Trouble etc.)
Function Used to cancel self diag trouble U2.
(Purpose)
Item Trouble
Operation/ 1. Press the [EXECUTE] key. (YES/NO key display)
Procedure 2. When YES key is pressed, the following troubles
are cleared. (Cancel with NO key.)
Error
Descriptions
Error
Error
AR-BC260 SIMULATION 9 - 21
(Trouble codes to be canceled)
Target trouble codes
U2-00 EEPROM read/write error (OPE)
U2-11 EEPROM check sum error (OPE)
U2-80 EEPROM read/write error (SCN)
U2-81 EEPROM check sum error (SCN)
U2-90 EEPROM read/write error (PCU)
U2-91 EEPROM check sum error (PCU)
17
17 -0
Purpose Clear/cancel (Trouble etc.)
Function Used to cancel self diag troubles PF (copy inhibition
(Purpose) command from the host computer).
Section Communication (RIC/MODEM)
Item Trouble
Operation/ 1. Press the [EXECUTE] key. (YES/NO key
Procedure display)
2. When YES key is pressed, the following troubles
are cleared. (Cancel with NO key.)
(Trouble codes to be canceled)
Target trouble codes
PF-00 PC copy inhibition signal reception
21
21 -1
Purpose Setting
Function Used to set the maintenance cycle.
(Purpose)
Item Specifications
Operation/ 1. The current setup is displayed. (Highlighted)
Procedure 2. When the maintenance cycle is selected with the
key, the selected key is highlighted.
The maintenance message is displayed in every selected cycle.
When FREE is selected, the maintenance display is not shown.
(Cycle to be set)
Item Set value
CYCLE 0
1
2
3
4
5
6
Descriptions
Error
Descriptions
Counter
Content Default
5K 50K
10K
15K
40K
50K
100K
FREE