Sharp AR-BC260 Service Manual page 145

Code
Function (Purpose)
Main Sub
44 1 Used to set enable/disable of
correction operations in the image
forming (process) section.
2 Black image density sensor
adjustment
4 Image forming section correction,
image density sensor adjustment
conditions setup
6 Used to forcibly execute the image
forming section correction (high
density process correction) (process
correction).
9 Used to check the data related to the
image forming section correction (the
corrected main charger grid voltage
in each print mode, the developing
bias voltage, etc.). (Used to check
that correction is performed normally
or not.)
12 Used to check the sampling toner
image patch density data in the
image forming section correction
(high-density correction) (process
correction). This simulation allows to
check if the correction operation is
performed normally.)
13 Color image density sensor
adjustment (Adjustment by the
adjustment jig)
14 Used to monitor the output level of
the fusing temperature sensor, the
machine temperature sensor, and
the humidity sensor.
21 Used to store color balance
adjustment data. (Half tone image
correction initial setting) (After
execution of color balance
adjustment with SIM 46-21, this
simulation must be executed.)
22 Used to check each color toner patch
image density UITU in half tone
image forming section correction
(process correction). (This simulation
allows to check if correction
operation is performed normally.)
24 Used to check the half tone
correction result. (This simulation
allows to check if correction is
executed properly or not.)
25 Setting the half tone correction
conditions.
26 Used to execute half tone correction
compulsorily.
27 Used to clear the half tone correction
data and set to the default level.
36 Color image density sensor and
black image density sensor
adjustment (simple adjustment)
46 1 Used to adjust the copy density of
each color copy mode in the low-
density area. The copy densities of
all colors in the low-density areas are
changed.
2 Used to adjust the copy density of
the low-density area in each
monochrome copy mode. The copy
density of the low-density area is
changed.
4 Used to adjust the image density
(color mode) in the network scan
mode.
Purpose
Setting Process
(Photoconductor,
developing, transfer,
cleaning)
Adjustment Process (Transfer)
Setting Process
(Photoconductor,
development, transfer)
Operation test/check Process
(Photoconductor,
developing, transfer,
cleaning)
Adjustment/Setting/ Process
Operation data output, (Photoconductor,
check (display, print) developing, transfer,
cleaning)
Adjustment/Setting/ Process
Operation data output, (Photoconductor,
check (display, print) developing, transfer,
cleaning)
Adjustment Process (Transfer)
Adjustment/Setting/ Others
Operation data output,
check (display, print)
Setting
Adjustment/Setting/ Process
Operation data output, (Photoconductor,
check (display, print) developing, transfer,
cleaning)
Adjustment/Setting/ Process
Operation data output, (Photoconductor,
check (display, print) developing, transfer,
cleaning)
Adjustment/Setting/ Process
Operation data output, (Photoconductor,
check (display, print) developing, transfer,
cleaning)
Adjustment Process
(Photoconductor,
developing, transfer,
cleaning)
Data clear Process
(Photoconductor,
developing, transfer,
cleaning)
Adjustment Process (Transfer)
Adjustment Process
(Photoconductor,
developing, transfer,
cleaning)
Adjustment Process
(Photoconductor,
developing, transfer,
cleaning)
Adjustment Scanner (reading)
AR-BC260 SIMULATION 9 - 7
Section
Operation
Operation
Picture quality
Operation
Data
Data
Picture quality
Data
Data
Data
Picture quality
Data
Picture quality
Picture quality
Picture quality
Item
Operation data
(Machine
conditions)
Operation data
(Machine
conditions)
Operation data
(Machine
conditions)
Operation data
(Machine
conditions)
Operation data
(Machine
conditions)
Density
Density
Density