Sharp AR-BC260 Service Manual page 50

g. Transfer roller
1) Remove the transfer unit from the machine.
2) Remove the connector and the screw, and remove the belt
drive unit.
3) Remove the transfer belt.
4) Disengage the pawl, and remove the bearing and the transfer
roller.
Conductive
Front Rear
Note for assembly:
There are two different transfer roller bearings: black and white.
The black bearing is conductive, and must be attached to the elec-
trode side (rear frame side).
h. Transfer drive roller
1) Remove the transfer unit from the machine.
2) Remove the connector and the screw, and remove the belt
drive unit.
3) Remove the transfer belt.
4) Remove the E-ring and the bearing, and remove the transfer
drive roller.
AR-BC260 DESCRIPTIONS OF EACH SECTION 7 - 13
i. Transfer follower roller
1) Remove the transfer unit from the machine.
2) Remove the connector and the screw, and remove the belt
drive unit.
3) Remove the transfer belt.
4) Remove the E-ring and the bearing, and remove the transfer
follower roller.
j. Transfer cleaning blade
1) Remove the transfer unit from the machine.
2) Remove the connector and the screw, and remove the belt
drive unit.
3) Remove the waste toner tank unit.
4) Remove the screw, and remove the transfer cleaning blade.
k. Transfer belt cleaning roller
1) Remove the transfer unit from the machine.
2) Remove the connector and the screw, and remove the belt
drive unit.
3) Remove the waste toner tank unit.
4) Press the cleaning lever in the arrow direction A, extend the
pawl in the arrow direction B, and pull up the cleaning lever in
the arrow direction C.
5) Remove the transfer belt cleaning roller.