B. Jumper Setting - Sharp AR-BC260 Service Manual

e. Initialize and/or store settings
You can restore the CONDITION SETTINGS and the key operator
program of the PRINTER SETTINGS to the factory default
settings.
You can also store the current configuration of these settings in
memory, and restore a stored configuration at a later time.
1) Restore factory defaults
This restores the CONDITION SETTINGS and the key operator
program of the PRINTER SETTINGS to the factory default
settings.
If you need a record of the settings prior to restoration of the
default settings, print the CUSTOM SETTINGS list and the key
operator program list.
This does not affect "Color adjustments" in the PRINTER
SETTINGS.
NOTE: After this program is set, exit the key operator program,
turn off the main switch, and then turn on the main switch
again after at least 3 seconds. The program will be effec-
tive at this time.
2) Store current configuration
This program is used to store the CONDITION SETTINGS and the
key operator program PRINTER SETTINGS in memory. The
stored settings will remain in memory even if the main switch is
turned off. To read the stored settings, use the following
[RESTORE CONFIGURATION] program.
This does not affect "Color adjustments" in the PRINTER
SETTINGS.
3) Restore configuration
This program is used to read the configuration that was stored
using the [STORE CURRENT CONFIGURATION] program and
restore it as the current configuration.
The currently set configuration will change to the configuration
read from memory.

B. Jumper Setting

Configuration for 3-pin jumper is shown as follows.
(1) Boot ROM Write Protect setting (JP1)
3
VCCWB
BOOT
Boot ROM Write Protect
Normal
Write Protect
(2) Battery setting (JP7)
BATTERY
JP7
3
OFF ⇔ ON
Battery
ON
OFF
JP1
1
L ⇔ H
JP1 Factory Default
1-2 Short
←
2-3 Short
1
JP7 Factory Default
←
1-2 Short
2-3 Short
AR-BC260 PRINTER CONTROLLER SECTION 14 - 11
6. Operation
A. Printer driver setting and operation
(1) Document mode and image process
Color
Original Standard
Type
Graphics
Photo
Drawing
(Thin
line)
Web
Page
Custom
Color Mode
Gray Scale Automatic