Sharp AR-BC260 Service Manual page 169

26
26 -2
Purpose Setting
Function 1. Used to set the paper size of the large capacity
(Purpose) tray. (When the paper size is changed, the
software setup must be changed accordingly
with this simulation.)
2. Used to detect 8.5 " x 13" (INCH Series) paper or
documents and to set the display mode. (All
paper feed modes)
3. Used to set the display form of the paper kind in
the manual paper feed mode.
Section Paper feed
Item Specifications
Operation/ 1. Used to set the paper size of the large capacity
Procedure tray.
2. Used to set to allow 8.5" x 13" size paper to be
treated as a selectable size.
3. Used to set the paper kind display mode in the manual paper
feed mode.
∗
Documents or paper of 8.5" x 13" are treated as a selectable
size.
(Selection item)
Item
Paper size LCC
setting
LEGAL
MFT TYPE
26 -3
Purpose Setting
Function Used to set the auditor specification mode. Setting
(Purpose) must be made according to the use conditions of the
auditor.
Section Auditor
Item Specifications
Operation/ Enter the code number corresponding to the auditor
Procedure specification mode.
Mode Content
[P10] Built-in auditor mode
[AR-EC1] Card counter mode (only Japan)
[MODE1] Coin vendor mode 1
[MODE2] Coin vendor mode 2
[MODE3] Coin vendor mode 3
Set value Content
1 8.5 x 11 (Default)
2 A4
0 8.5 x 14 (Default)
1 8.5 x 13
0 Displayed in gram.
1 Displayed in pound.
AR-BC260 SIMULATION 9 - 31
[Copy vendor mode]
Lack of money during a
Specified
number
completed
Diag BW/Color
with money
setting (with no
left
money left)
Case 1 Case 2
26-3=3
Operation 1 Operation 2 Operation 2
MODE1
26-3=4
Operation 1 Operation 1 Operation 2
MODE2
26-3=5
Operation 1 Operation 3 Operation 2
MODE3
Operation 1: The set status remains until the auto clear set
time has passed. (Default: 60sec Changeable
with key operations.)
Operation 2: Auto clear is not made.
Operation 3: Setting is immediately cleared, and the display
returns to the standby menu.
Case 1/Case 2 (with money left): B/W copy is allowed. If, however,
charge money fro color copy is exhausted during a color copy job,
when sufficient money for the job is supplied, only the color start
key of the READY lamp lights up.
26 -5
Purpose Setting
Function Used to set the count mode of the total counter and
(Purpose) the maintenance counter.
Item Specifications
Operation/ Used to set the single count-up or double count-up
Procedure for the total counter, the maintenance counter, and
the developer counter when printing is performed
with A3, 11 x 17" paper.
1. Select the kind of the counter with the scroll key.
2. Enter "1" or "2" with the 10-key pad and press the [OK] key.
Item Content
A TOTAL(B/W) Total counter (B/W)
B TOTAL(COL) Total counter (Color)
C MAINTE(B/W) Maintenance (B/W)
D MAINTE(COL) Maintenance (Color)
Specified
copy job
number
completed
Color (with
with no
money left)
money left
Case 3 Case 4
Operation 1
Operation 1
Operation 3
Counter
Set range Default
1 – 2 2
1 – 2 2
1 – 2 2
1 – 2 2