Sharp AR-BC260 Service Manual page 155

5 -4
Purpose Operation test/check
Function Used to check the operations of the discharge lamp
(Purpose) and its control circuit.
/
Section Process (Photoconductor, developing,
transfer, cleaning)
Item Operation
Operation/ 1. Select the target discharge lamp with the [K], [C],
Procedure [M], and [Y] keys. (K: Black, C: Cyan,
M: Magenta, Y: Yellow)
2. When the [EXECUTE] key is pressed, the key is highlighted
and the selected discharge lamp is lighted for 30sec. If the
[EXECUTE] key is pressed while the lamp is lighted, the lamp
is turned OFF.
6
6 -1
Purpose Operation test/check
Function Used to check the operations of the loads (clutches
(Purpose) and solenoids) in the paper transport system,
transfer, and fusing, and the control circuit.
Section Paper transport (paper exit, switchback, transport),
transfer, fusing
Item Operation
Operation/ 1. The names of the loads that can be checked are
Procedure displayed. Select the load to be checked with the
key, and the selected load is highlighted.
2. Press the [EXECUTE] key. The selected load
starts the operation. During the operation of the
load, the [EXECUTE] key is highlighted. If the
[EXECUTE] key is pressed while it is highlighted,
the operation is stopped.
(Loads to be selected)
CPFC Cassette transport clutch
TRC Cassette paper feed clutch
MTRC Manual paper feed clutch
MPFC Manual transport clutch
GSS Paper exit gate select solenoid
RRM Resist roller motor (PSM)
PFM Paper feed motor (Vertical transport)
FUM Fusing motor
BLUM Lift motor
BLUM (R) Lift motor (Reverse rotation/waste toner transport
motor)
OSM Offset motor (Job separator)
CARB Calibration plate
∗
When BLUM is ON, the belt moves up.
When BLUM is OFF, the belt moves down.
6 -2
Purpose
Function
(Purpose)
Others Section
Item
Operation/
Procedure
2. Press the [EXECUTE] key.
The selected load is operated. During operation, the
[EXECUTE] key is highlighted. If the [EXECUTE] key is
pressed while it is highlighted, the operation is stopped.
(Loads to be selected.)
VFM1
VFM2
PSFM
PRTCFM
SIROCCOFM
7
7 -1
Purpose
Function
(Purpose)
Item
Operation/
Procedure
∗
The setup contents of this simulation remain unchanged until
the power is turned off. When this simulation is executed, SIM 7-
8 (Warm-up time display setting) is canceled.
(Set content)
[AGING]
[INTERVAL]
[MISFEED DISABLE]
[FUSING DISABLE]
[WARMUP DISABLE]
[DV CHECK DISABLE] Developing tank detection YES/NO setup
[SHADING DISABLE]
[CCD GAIN FREE]
AR-BC260 SIMULATION 9 - 17
Operation test/check
Used to check the operations of the fan motors and
the control circuits.
Others
Operation
1. The loads that can be checked are displayed.
Select one to be checked.
Fusing fan 1
Fusing fan 2
Power fan
Process exhaust fan
Sirocco fan
Setting/Operation test/check
Used to set the aging conditions.
Operation
1. Press each corresponding key to set for the
aging operation.
(Set items of each key)
The selected key is highlighted.
2. Press the [EXECUTE] key.
Aging is set and the display returns to the
simulation main code entry menu.
Jam detection setup
Intermittent setup
Jam detection YES/NO setup
Fusing operation YES/NO detection
Warm-up saving setup
Shading saving setup
No setting of CCD gain adjustment