Lan Port - Furuno Felcom 250 Service Manual

LED
POWER Lighted when the power is turned on.
Lighted: Authentication (usage permission) for Circuit Switched (Voice/Fax)
READY
Blinking (at an interval of 1.0 s): Satellite signal detected
Light off: Satellite search in process
Lighted: Transmission in process (IF ON)
TX
Light off: Not transmitted yet (IF OFF)
Lighted: No modem alarm / warning
1 Blinking (at an interval of 1.0 s): Modem warning currently occurred
Blinking (at an interval of 0.2 s): Modem error currently occurred
Lighted: No HUB alarm / warning
2 Blinking (at an interval of 1.0 s): HUB warning currently occurred
Blinking (at an interval of 0.2 s): HUB error currently occurred
STATUS
Lighted: No ADE alarm / warning
3 Blinking (at an interval of 1.0 s): ADE warning currently occurred
Blinking (at an interval of 0.2 s): ADE error currently occurred
Lighted : No Handset alarm / warming
4 Blinking (at an interval of 1.0 s): Handset warning currently occurred
Blinking (at an interval of 0.2 s): Handset error currently occurred

2. LAN Port

The ports currently establishing communication have both green and orange LEDs
lighted/blinking.
- GREEN: Lnk/Act
Lighted: Linkage established, Turned off: Linkage not established yet,
Blinking: Data currently being transmitted/received
- YELLOW: Fulld/Col
Lighted: Full duplex, Turned off: Half-duplex, Blinking: Collision currently
occurred
10.7 LED and DIP Switch for the Communication unit
Table 10.7.1 The statuses shown on the panel LED
or Packet Switched has been successfully provided, or the
Tracking Status is set to "Track".
10-34
Description