Furuno Felcom 250 Service Manual page 32

Note
(1) Call charge is calculated from the call arriving (Audio Guidance A).
(2) Calling charge is calculated from the call arriving at ship and counting during
ringing.
(3) All phones set in "Incoming routing" are called.
- In case of dialing the # with no dial of extension number.
- In case of timing out of incoming calling when connecting to the specified
phone and getting no answer.
- In case of mis-dialing extension number 3 times.
(4) Audio Guidance B is provided to dial the extension number again in case of the
line is not registered.
(5) Audio Guidance C is repeated in case of the line is not available (Busy, Off line
and call rejection, etc.).
(6) Audio Guidance A is provided and the call is automatically terminated with no
dial of extension number for 30 seconds.
2. AT command port can process three sessions.
Three AT command sessions can be processed in parallel at LAN port.
By adding this capability, data connection/disconnection can be operated by
Mailer.
3. AT command can be arrived automatically.
AT command of ISDN UDI (Unrestricted Digital Information)/RDI (Restricted
Digital Information) can be received automatically.
FELCOM 250/500 can be responded the call from shore side and connected to
ISDN automatically.
4. Even though PIN code is set, Emergency Call can be sent.
Previously, when PIN code was set, Emergency Call could not be sent from
Handset. By adding this capability, even though PIN code is set, Emergency Call
can be sent from Handset.
added
3/5