Furuno Felcom 250 Service Manual page 399

84. Notice 9519: (SIM) OTAP message is received. EF_SUPPORT_TEL is changed.
The status for this notice message is constantly confirmed at an interval of 1 second.
This message occurs when the SIM data has been changed by OTA.
85. Notice 9520: (SIM) OTAP message is received. EF_SERVICE_URL is changed.
The status for this notice message is constantly confirmed at an interval of 1 second.
This message occurs when the SIM data has been changed by OTA.
86. Notice 9521: (SIM) OTAP message is received. EF_DP_INFO_URL is changed.
This notice message occurs when the SIM data has been changed by OTA.
87. Notice 9522: (SIM) OTAP message is received. Another EF is changed.
The status for this notice message is constantly confirmed at an interval of 1 second.
This message occurs when the SIM data has been changed by OTA.
88. Handset 9601: (Handset) LAN link fault.
The status for this error is confirmed when the system is activate or during selftest.
This error occurs when linkage is not established using the Ethernet cable. It implies
a failure in the handset.
89. Handset 9602: (Handset)No Comm. Unit.
The status for this error is constantly confirmed at an interval of 20 seconds. This
error occurs when the Communication unit cannot be detected. It implies a
connection failure with the HUB board.
90. Warning 9603: (Handset) PHY IC fault.
The status for this error is confirmed when the system is activate or during selftest.
This error occurs when there is an abnormality in the handset internal PHY IC. It
implies a failure in the Handset.
91. Warning 9604: (Handset) CODEC IC fault.
The status for this error is confirmed when the system is activate or during selftest.
This error occurs when there is an abnormality in the Handset internal Codec IC. It
implies a failure in the Handset.
92. Warning 9605: (Handset) LCD fault.
The status for this error is confirmed when the system is activate or during selftest.
This error occurs when there is an abnormality in the Handset internal LCD driver. It
implies a failure in the Handset.
AP2-16
Appendix 2. Message List