Furuno Felcom 250 Service Manual page 393

35. Notice 9206: (HUB) Some LaunchPads are connected.
The status for this error is confirmed when operation is made for LaunchPad. This
error occurs when concurrent connection is made from several PCs to BDE using
LaunchPad.
Only a single LaunchPad can establish connection with BDE.
36. Warning 9207: (HUB) Controller fault.
The status for this error is confirmed when the system is activated. This error occurs
when there is an abnormality in the HUB Controller in the HUB board.
Communication is not available. It implies a failure in the HUB board.
37. Notice 9208: (HUB) 2 PS Connections detected with 2 ways.
The status for this error is confirmed on a constant basis when operation is made.
This error occurs when PS: Packet Switching connection is attempted to be
established by 2 or more methods such as by Web MMI and by LaunchPad.
38. Error 9209: (HUB) FPGA fault.
The status for this error is confirmed when the system is activated. This message will
be output when FPGA configuration for the HUB board has failed.
Please update the HUB software to restore the soft image. It implies a failure in the
HUB board.
39. Notice 9210: (HUB) Modem reply fault.
The status for this error is confirmed in a constant basis. This error occurs when there
is an abnormality in the communication between the MODEM board and the HUB
board. There are some cases that this error would occur temporarily; if the error
occurs on a constant basis, communication will not be available. If the status does not
get restored after having rebooted the system, replace the HUB board.
40. Warning 9211: (HUB) No reply from Modem.
The status for this error is confirmed on a constant basis at an interval of 3 seconds
and during selftest.
This error occurs when there is an abnormality in the communication between the
MODEM board and the HUB board. Although there is a possibility that the
abnormality is observed as a temporary status, if the abnormality is confirmed to be
constant, communication will not be available. Please reboot the system. Please
update the HUB software. It implies a failure in the MODEM board, HUB board, or
the IF board.
41. Warning 9212: (HUB) ROM fault.
The status for this error is confirmed during selftest. This will be issued when there is
an error for reading from/writing into the ROM in HUB board. Please replace the
board. It implies a failure in the HUB board.
AP2-10
Appendix 2. Message List