Maintenance - Furuno Felcom 250 Service Manual

General access codes
Short code
12
28
33
36
57
94
505
8. Every PCs and Handsets can set IP filter. The setting is Settings -> Network settings
-> Security -> IP Filter.

3. Maintenance

1. After 3 to 4 minutes have passed after having turned on the power, all panel LEDs
upon the Communication unit excluding the "TX" LED would have to be turned ON.
The lighting status for the 4 "STATUS" LEDs shows the part where the failure is
occurring.
2. Communication will not be available if "Ready" LED is not turned on. The
conditions for having the light turned on are;
The Antenna is in tracking status
Registration to the BGAN network is completed for both CS and PS
Note that registration will not be available unless you have the GPS data.
3. The Web MMI has the Users' mode, Administrator's mode, and Service mode. The
Handsets have Administrator's password, too.
Applied for;
Calling Administrator's
mode from the Web MMI
Calling Service mode
from the Web MMI
SIM: PIN 1 Code
SIM: PUK1 Code
SMS menu
Calling Administrator's
mode from the Handset
Access to a DP's (Distribution partner) directory enquiry system
Access to a DP's ISP service
Access to a DP's customer service/technical help desk
Access to a DP's credit card calling system
Voice mail service (Voice mail access: +00 870 77200 1899)
Access to a DP's automatic loop back/test system
Emergency Call
User Name
/Password
(Default)
Admin/
01234567
Service/
fb5963
Described upon
the SIM card
Described upon
the SIM card
01234567
01234567
Action
Note) Depend on DP service
Password alone can be changed individually:
Settings -> Change Password
This cannot be changed.
Possible to be changed upon the Web MMI
SIM -> Change PIN
This cannot be changed.
Possible to be changed upon the Web MMI
Settings -> SMS server
Note) The password is the same for other PCs or
the Handsets.
Possible to be changed individually:
Main -> Settings -> 4. Password
6
Summary
Notes