Ip Ssh Hostbased-Authentication - Dell S4810 Reference Manual

ip ssh hostbased-authentication

Enable hostbased-authentication for the SSHv2 server.
S4810
Syntax
ip ssh hostbased-authentication enable
To disable hostbased-authentication for SSHv2 server, use the no ip ssh
hostbased-authentication enable command.
Parameters
enable
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
If you enable this command, clients can log in without a password prompt. This
Information
command provides two levels of authentication:
•
•
Related
ip ssh pub-key-file
Commands
Security
Enter the keyword enable to enable hostbased-
authentication for SSHv2 server.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
rhost-authentication is done with the file specified in the ip ssh rhostfile
command.
checking client host-keys is done with the file specified in the ip ssh pub-
key-file command.
NOTE: Administrators must specify the two files (rhosts and pub-key-file)
to configure host-based authentication.
— public keys of trusted hosts from a file.
1511