Privilege Level (Configuration Mode) - Dell S4810 Reference Manual

local
tacacs+
none
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.1.1.0

privilege level (CONFIGURATION mode)

Change the access or privilege level of one or more commands.
S4810
Syntax
privilege mode {level level command | reset command}
To delete access to a level and command, use the no privilege mode level
level command command.
Parameters
mode
Security
Use the authorization parameters on the system to perform
authorization.
Use the TACACS+ protocol to perform authorization.
Enter the keyword none to apply no authorization.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for RADIUS.
Enter one of the following keywords as the mode for which
you are controlling access:
• configure for CONFIGURATION mode
• exec for EXEC mode
• interface for INTERFACE modes
• line for LINE mode
• route-map for ROUTE-MAP mode
• router for ROUTER OSPF, ROUTER RIP, ROUTER ISIS
and ROUTER BGP modes
1457