Logging Buffered - Dell S4810 Reference Manual

Version 9.4.
(0.0)
Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.4.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage Multiple logging servers of both IPv4 and/or IPv6 can be configured.
Information
Related
logging on
Commands
Syslog server, and terminal lines.
logging trap

logging buffered

Enable logging and specify which messages are logged to an internal buffer. By default, all messages are
logged to the internal buffer.
S4810
Syntax
logging buffered [level] [size]
To return to the default values, use the default logging buffered command.
To disable logging stored to an internal buffer, use the no logging buffered
command.
Parameters
level
size
1584
Added support for VRF.
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for IPv6.
Introduced on the S-Series.
Introduced on the C-Series.
— enables the logging asynchronously to logging buffer, console,
— enables logging to the Syslog server based on severity.
(OPTIONAL) Indicate a value from 0 to 7 or enter one of the
following equivalent words: emergencies, alerts,
critical, errors, warnings, notifications,
informational, or debugging. The default is 7 or
debugging.
(OPTIONAL) Indicate the size, in bytes, of the logging buffer.
The number of messages buffered depends on the size of
Simple Network Management Protocol (SNMP) and Syslog