Dell S4810 Reference Manual page 1379

Field
stack-unit
Portpipe
CAM Partition
Available CAM
Estimated CAM
per Port
Status (Allowed
ports)
Example
Dell# test cam-usage service-policy input pmap_l2 stack-unit
all
For a L2 Input Policy Map pmap_l2, the output must be as
follows,
stack-unit|Portpipe|CAM Partition|Available CAM|Estimated CAM|
Status
(Allowed ports)
0
Allowed (2)
0
Exception
1
Allowed (5)
1
Exception
13
Quality of Service (QoS)
Description
Indicates the stack-unit slot number.
Indicates the portpipe number.
The CAM space where the rules are added.
Indicates the free CAM space, in the partition, for the
classification rules.
NOTE: The CAM entries reserved for the default rules
are not included in the Available CAM column; free
entries, from the default rules space, cannot be used as
a policy map for the classification rules.
Indicates the number of free CAM entries required (for the
classification rules) to apply the input policy map on a single
interface.
NOTE: The CAM entries for the default rule are not
included in this column; a CAM entry for the default rule
is always dedicated to a port and is always available for
that interface.
Indicates if the input policy map configuration on an
interface belonging to a stack-unit/port-pipe is successful
— Allowed (n) — or not successful — Exception. The
allowed number (n) indicates the number of ports in that
port-pipe on which the Policy Map can be applied
successfully.
NOTE: In a Layer 2 Policy Map, IPv4/IPv6 rules are not allowed; therefore, the
output contains only L2ACL CAM partition entries.
| |
0
1
0
1
1
|
L2ACL 500
L2ACL 100
L2ACL 1000
L2ACL 0
...
...
...
L2ACL 400
|per Port |
200
200
200
200
200
1379