Dell S4810 Reference Manual page 1489

Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
tacacs-server group
Creates a group of TACACS servers.
S4810
Syntax
tacacs-server group group-name
To delete a group of TACACS servers, use the no tacacs-server group
group-name command.
Parameters
group-name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage You can associate a TACACS server group with a VRF.
Information
Example
Dell(conf)#tacacs-server group group1
Dell(conf-tacacs-group)#tacacs-server host 1.1.1.1 key secret
Dell(conf-tacacs-group)#tacacs-server host 2.2.2.2 key secret
Dell(conf-tacacs-group)#tacacs-server vrf vrf1 source-
interface tengigabitethernet 0/36
Dell(conf-tacacs-group)#show config
!
tacacs-server group group1
tacacs-server vrf vrf1 source-interface TenGigabitEthernet 0/36
tacacs-server host 1.1.1.1 key 7 9a2f3ec0c65c6f41
tacacs-server host 2.2.2.2 key 7 9a2f3ec0c65c6f41
Dell(conf-tacacs-group)#
Related
aaa authentication login
Commands
Security
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the name of the TACACS server group.
Introduced on the S-Series and Z-Series.
— specifies the login authentication method.
1489