Redistribute Ospf - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
pre-Version
6.2.1.1

redistribute ospf

Redistribute routing information from an OSPF process.
S4810
Syntax
redistribute ospf process-id [match external {1 | 2} | match
internal | metric metric-value] [route-map map-name]
To disable redistribution, use the no redistribute ospf process-id [match
external {1 | 2} | match internal | metric metric-value]
[route-map map-name] command.
Parameters
process-id
match external
{1 | 2}
match internal
metric metric-
value
route-map
map-name
Defaults Not configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Routing Information Protocol (RIP)
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Enter a number that corresponds to the OSPF process ID to
redistribute. The range is from 1 to 65355.
(OPTIONAL) Enter the keywords match external then the
numbers 1 or 2 to indicated that external 1 routes or external
2 routes should be redistributed.
(OPTIONAL) Enter the keywords match internal to
indicate that internal routes should be redistributed.
(OPTIONAL) Enter the keyword metric then a number as
the metric value. The range is from 0 to 16.
(OPTIONAL) Enter the keywords route-map then the name
of a configured route map.
Introduced on the S6000.
1407