Access-Class - Dell S4810 Reference Manual

radius-server host
tacacs-server host

access-class

Restrict incoming connections to a particular IP address in a defined IP access control list (ACL).
S4810
Syntax
access-class access-list-name
To delete a setting, use the no access-class command.
Parameters
access-list-
name
Defaults Not configured.
Command LINE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Related
line
Commands
ip access-list standard
the IP address.
ip access-list extended
IP addresses or protocols.
Security
— specifies a RADIUS server host.
— specifies a TACACS+ server host.
Enter the name of an established IP Standard ACL.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— applies an authentication method list to the designated terminal lines.
— names (or selects) a standard access list to filter based on
— names (or selects) an extended access list based on the
1463