Dell S4810 Reference Manual page 1485

Hide thumbs Also See for S4810:
Table of Contents

Advertisement

To configure zero retransmit attempts, use the no radius-server retransmit
command.
To return to the default setting, use the radius-server retransmit 3
command.
Parameters
retries
Defaults
3 retries
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Related
radius-server host
Commands
radius-server timeout
To reply to a request, configure the amount of time the RADIUS client (the switch) waits for a RADIUS
host server .
S4810
Syntax
radius-server timeout seconds
To return to the default value, use the no radius-server timeout command.
Parameters
seconds
Security
Enter a number of attempts that FTOS tries to locate a
RADIUS server. The range is from zero (0) to 100. The default
is 3 retries.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures a RADIUS host.
Enter the number of seconds between an unsuccessful
attempt and the Dell Networking OS times out. The range is
from zero (0) to 1000 seconds. The default is 5 seconds.
1485

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents