Show Qos Class-Map - Dell S4810 Reference Manual

Usage There are eight queues per interface on the S6000 and four queues on the S-
Information Series. This command assigns a class map or QoS policy to different queues.
Related
class-map
Commands
service-policy input
service-policy output
set
Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.
S4810
Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp value
Defaults none
Command CONFIGURATION (conf-qos-policy-in)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Usage
After the IP DSCP bit is set, other QoS services can then operate on the bit settings.
Information

show qos class-map

View the current class map information.
S4810
Syntax
show qos class-map [class-name]
Parameters
class-name
Quality of Service (QoS)
— identifies the class map.
— applies an input policy map to the selected interface.
— applies an output policy map to the selected interface.
(OPTIONAL) Enter the keywords ip-dscp then the IP DSCP
value. The range is from 0 to 63.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
(Optional) Enter the name of a configured class map.
1369