Restore Factory-Defaults - Dell S4810 Reference Manual

Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series

restore factory-defaults

Restore factory defaults.
S4810
Syntax
restore factory-defaults stack-unit {0-5 | all} {clear-all |
nvram}
Parameters
factory-
defaults
0-5
all
clear-all
nvram
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
72
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series
Introduced on C-Series
Original command
Return the system to its factory default mode.
Enter the stack member unit identifier to restore only the
mentioned stack-unit.
Enter the keyword all to restore all units in the stack.
Enter the keywords clear-all to reset the NvRAM and the
system startup configuration.
Enter the keyword nvram to reset the NvRAM only.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
File Management