Dell S4810 Reference Manual page 1051

Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.12.0
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage The following describes the show mac-address-table command shown in the
Information
following example.
Column Heading
VlanId
Mac Address
Type
Interface
Layer 2
static addresses, dynamic addresses, and MAC addresses in
use.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Updated the output.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the VLAN ID number.
Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Lists whether the MAC address was manually configured
(Static), learned dynamically (Dynamic), or associated with a
specific port (Sticky).
Displays the interface type and slot/port information. The
following abbreviations describe the interface types:
• gi — Gigabit Ethernet then a slot/port.
• po — Port Channel then a number. The range is from 1
to 255 for TeraScale.
• so —SONET then a slot/port.
• te — 10 Gigabit Ethernet then a slot/port.
1051