Programming Maintenance Work - New Holland Workmaster 50 Operator's Manual

Programming maintenance work

Setting a maintenance reminder for heavy-duty use
This function allows the operator to program maintenance
according to two levels of importance: "routine (LIGHT)"
or "heavy-duty use (HEAVY)". Proceed as follows:
1. Press the switch (1) on the symbol (B) for more than
three seconds to enter the programming menu
The display will show "SETUP MENU". Release the
switch.
2. Press the switch (2) on the symbol (D) a number of
times until the display shows the symbol for program-
ming maintenance intervals (S1).
3. Press the switch (1) on the symbol (B). The display
will show the "Heavy" screen with the hours that re-
main until maintenance is due. The setting cannot be
changed at this stage.
NOTE: As the time for the programmed work approaches, the display will show a warning in the number of operating
hours that remain until maintenance is due. At the end of the countdown, the display will show "Heavy " followed by an
alarm message to indicate that the time has expired. At the end of the count, in the maintenance work programming
menu, the counter will show three dashes and must be re-programmed as described above.
3 - CONTROLS AND INSTRUMENTS
MOIL12TRO0048FD
4. Press the switch (1) on the symbol (B) to change the
5. Press the switch (2) on the symbol (C) to increase the
6. If you do not want to save the new setting and go back
7. To save the new maintenance schedule, press the
8. After two seconds, you will exit the programming
3-25
1
setting of the first flashing digit. (In the above example,
the number "2").
value. Press the same switch on the symbol (D) to
move to the next digit.
to the start of programming, press the switch (1) on the
symbol (A).
switch (1) on the symbol (B). The display will show
confirmation that the new value has been saved.
menu for maintenance operations.