Digital Instrument, Warning Lights - Husqvarna CR 1225 2012 Quick Manual

DIGITAL INSTRUMENT, WARNING LIGHTS

The motorcycle is equipped with a digital instrument;
on the instrument are located 2 warning lights too: high
beam and blinkers .
1- BLUE warning light "HIGH BEAM"
2- GREEN warning light "BLINKERS"
The instrument display illuminates (amber colour) when
the engine started .
NOTES
- Every time the engine starts, for the first 2 seconds,
the instrument shows the version of the checking SW;
after the check, the instrument shows the last planned
function .
- When the motorcycle engine is OFF, the instrument
doesn't also show its functions.
- To select the instrument functions and to set to zero
the functions, use the SCROLL knob (A) .
1
2
EN - 12 QUICK MANUAL
8000H7113-CR-WR125_MY2012_ed0_06-2011.indd 12
- The instrument functions are the following, as shown
below .
1- SPEED / ODO (figure 1)
2- SPEED / CLOCK (figure 2)
3- SPEED / TRIP (figure 3)
4- SPEED / CHRONO (figure 4)
1- SPEED / ODO (figure 1)
. . . . . . . . . . . . . . . . .
A
1- SPEED (Km/h or mph) / ODO (figure 1)
- SPEED: motorcycle speed- maximum value: 299 Km/h
or 299 mph;
- ODO: odometer- maximum value: 99999 km;
To replace kilometers with miles or miles with kilometers
proceed as follows:
1) set to figure 1, stop the engine and push the knob
SCROLL (A);
2) Start the engine holding pushed the button SCROLL (A)
until the symbol "Km/h" will be displayed;
3) then the symbols "Km/h" and "Mph Miles" will be
displayed alternatively . Push again the SCROLL (A)
button when the unit you wish to use is displayed .
A
12-07-2011 9:02:06