Stripping Down And Re-Assembling Intermediate Flange - BMW K 1100 LT/RS Repair Manual

Stripping down and re-assembling
intermediate flange
Removing the driver bearing
Bearing plate (1)
•
Cup spring (2)
•
Pull out ball bearing (3) with counter-support,
•
BMW No. 00 8 572, and internal puller 21/2,
BMW No. 00 8 571.
Seeger circlip (4)
•
Installing driver bearing
Heat the intermediate flange at the bearing seat
•
to 120 °C.
Press the ball bearing in as far as the Seeger cir-
•
clip.
j
120
2
3
4
Insert the cup spring with the larger diameter fac-
•
ing the bearing.
Install the bearing plate with the large cutout fac-
•
ing upwards.
The retaining screws must be clean and free
•
from grease; insert them with Loctite 243.
X
Tightening torque:
Bearing plate.................................................. 9 Nm
1
LT110120
LT110130
11.15