Epson DFX 9000
5.3.5 Left margin adjustment
Adjust the print start position from the left edge of the paper.
This adjustment is required after you remove or replace these parts:
PR MECHA ASSY
CARRIER UNIT
ROM BOARD (only when the EEPROM Data Copy fails)
Tools / materials: Adjustment Program
Paper: 1 sheet of 64 g/m
5 sheets of 39.5 g/m
10 sheets of 50 g/m
Objective:
Left margin of 116.8 mm ± 0.5 mm (4.6 ± 0.2 inch)
measured from inside Side Frame, Left.
Adjustment Procedure
1. Set the 1, 5 or 10 sheets of paper in the tractor, and load the paper by
pressing the [Load] button.
2. From the Adjustment Program, select the
3. Click
in
to print the left margin check pattern with the
Print
Mode A
adjustment value currently saved in EEPROM.
4. Refer to
Figure
5-30, and measure the distance between the printed
left line and the left frame. Check whether the distance matches the
specification: 116.8 mm ± 0.5 mm.
5. If the line needs adjustment, type an adjustment value for each mode
into each of the input boxes, where 1 step = 1/480 inch.
A negative (e.g., "-12") value moves the print position to the right,
and a positive value moves it to the left.
6. Click
to save the new parameter for next print test.
Write
Adjustment
2
(15 lb)
2
(10.5 lb)
2
(13 lb)
.
Left Margin Adjustment
Software adjustment
7. Click
again to print the left margin check pattern with the new
Print
parameters.
8. Repeat Step 4 to Step 7 until the margin is within specifications.
9. Make the same adjustment for each print mode, and each paper
thickness.
Figure 5-29. Left Margin Adjustment screen
Measurement
Figure 5-30. Measurement point
Revision B
distance
Scale
247