Adjustment - Epson DFX-9000 Service Manual

Epson DFX 9000
Secure the FTRPE sensor cable with the cable clamps,
making length adjustments to meet the following
conditions:
Too much tension should not be applied to the cable
when moving the TRACTOR FL UNIT to the right.
The cable should not interfere with the Tractor shaft
when moving the TRACTOR FL UNIT to the left.
8. Remove the two C.P. (S-P1) 3 × 10 screws that secure the Sub shaft,
move the Sub shaft to the recess holes on the SIDE FRAME, LEFT
and SIDE FRAME, RIGHT, and then pull out the Sub shaft.
9. Remove the E-ring that secures the right end of the Tractor shaft, and
remove the washer, spring washer, and the bearing.
When installing the Tractor shaft, attach the spring washer
in the direction shown in
Place the Spring Washer with the bow facing the center of
the tractor shaft.
10. Pull out the Tractor shaft to the left.
The TRACTOR FL UNIT and TRACTOR FR UNIT have
phases that must be matched. Align the phase marks of the
TRACTOR FL UNIT and TRACTOR FR UNIT before
installing the Tractor shaft. See
(B).
Disassembly and Assembly
Figure 4-50, Reassembly (A).
Figure 4-50, Reassembly
TRACTOR UNIT
Reassembly (A)
Spring washer
Tractor Shaft
Washer E-Ring
10)
8)-1
Phase mark
Reassembly (B)
Figure 4-50. TRACTOR FL UNIT/TRACTOR FR UNIT Removal (2)
Revision B
Spring washer
8)-1
8)-2
Recess hole
9)
171