Epson DFX-9000 Service Manual page 22

Epson DFX-9000
Approved joining of multipart form sheets
Don't use continuous multipart forms that are joined with
C A U T I O N
metal staples, one sided crimping, tape-staples, or bar-
gluing.
Figure 1-4. Spot gluing on both sides
The thickness of the crimped part when extended should be less than 0.9 mm.
Figure 1-5. Combination spot gluing and crimping
Product Description
The thickness of the crimped part when extended should be less than 0.9 mm.
The any crimp deformation of the paper surface must be on the bottom, and not the
printing surface.
The thickness of the perforation part
The thickness of the tenting at the perforation fold should
be 2 mm or less.
Figure 1-7. The thickness of the perforation area
Basic specifications
Printing Side
Figure 1-6. Crimping both sides
Revision B
Non printing
Side
15