Epson DFX-9000 Service Manual page 59

Epson DFX-9000
The instructions and current settings are printed out in the
C H E C K
P O I N T
language that you set in the SelecType mode. If you want
to change the language, change the language setting in the
SelecType mode. See
(p.46) for details.
3. Select one of the three main menus by pressing the [Set↑] (Tear Off)
or [Set↓] (Top of Form) button:
.
Panel lock out
4. If you select , press the [Item↓] (Pitch) button to print
Print Settings
the current settings.
If you select
Form w/labels
(Font) or [Item↓] (Pitch) button to select the items you want to
change.
5. Press the [Set↑] (Tear Off) or [Set↓] (Top of Form) button to select
the values within the selected parameter until you find the desired
setting.
In Step 3 to 5 above, you can scroll through the values by
C H E C K
P O I N T
holding down the [Set↑] (Tear Off), [Set↓] (Top of Form),
[Item↑] (Font), or [Item↓] (Pitch) button for a few seconds.
6. After setting the selected parameter to the desired value, you may
either continue to make changes to other parameters by pressing the
[Item↓] button or the [Item↑] button, or exit the power-on default-
setting mode.
7. When you finish the settings, turn the printer off.
The menu is designed as a loop. After the last menu
C H E C K
P O I N T
parameter is displayed, the next menu item will be the first
menu.
Product Description
1.3.3 SelecType functions setting
,
Print settings Form w/labels
or , press the [Item↑]
Panal lock out
The values available for power-on default and factory settings are shown
in the table below. The underlined value is the factory default settings.
Table 1-37. Values available in default setting mode
Item
Select settings
Label base pos.
, or
Label top pos.
Label length
Label left pos.
Label width
Base sheet PG
Label paper PG 0 to 14
Notes: 1. Refer to
2. This setting is the function that prints the current settings.
Error analysis mode (acquire EEPROM information)
This printer mode allows the host system to communicate with the
printer while it is in an error state.
To enable Error Analysis mode, turn the power on while holding down
the [Front] and [Pitch] buttons. The printer beeps once, and enters IEEE
1284.4 Protocol mode.
NOTE: The printer forcibly enters IEEE 1284.4 packet mode even if
a fatal error has occurred, and communication with the PC
becomes available. This mode is used with the Adjustment
Program to get information from the printer when it is in a
fatal error condition.
Operations
Setting Values
Forms w/labels, Panel lock out
Paper left edge, First dot
0/216 inches to 4752/216 inches
0/216 inches to 4752/216 inches
0/120 inches to 1440/120 inches
0/120 inches to 1440/120 inches
0 to 14
Panel lock out mode, p. 51 for details.
Revision B
1 2
, Print settings
52