Epson DFX 9000
4.2.4.9 RF MOTOR
Do not touch the RF MOTOR immediately after using the
W A R N I N G
printer, or you may burn your hand. Allow the motor to
cool enough to work with it.
1. Remove the
UPPER UNIT (p. 135)
2. Tilt up the rear of the PR MECHA ASY and support it using the tilt
bar.
Refer to section 4.2.4.1 PR MECHA ASY, p. 149.
3. Release the RF MOTOR cable from the three cable clamps (SIDE
FRAME, RIGHT: 2 places, bottom rear: 1 place).
4. Release the RF MOTOR cable from the SENSOR BOARD UNIT
(CNRB: 4 pins), and pull the RF MOTOR cable out through the hole
in the SIDE FRAME, RIGHT.
5. Remove the two C.B.S. 3 × 6 screws that secure the RF MOTOR to
the SIDE FRAME, RIGHT, and remove the RF MOTOR.
When installing the RF MOTOR, take care not to damage
the pinion gear attached to the motor when you pass it
through the hole in the side frame.
Disassembly and Assembly
Cable clamp
5)
5)
RF MOTOR
Figure 4-42. RF MOTOR Removal
RF MOTOR
Cable clamp
[Front]
SENSOR BOARD UNIT
4)-1 CNRB
[Rear]
Revision B
163