Epson DFX-9000 Service Manual page 208

Epson DFX 9000
TPE HOLDER ASY
Disconnect the power cable and wait at least 5 minutes
W A R N I N G
for capacitors to drain before disassembling the
POWER UNIT. If you touch the POWER UNIT with
the power supplied, you may receive an electric shock.
Do not touch the motors immediately after using the
printer, or you may burn your hand. Allow the motors
to cool enough to work with them
1. Remove the UPPER UNIT (p. 135)
2. Tilt up the rear of the PR MECHA ASY and support it using the tilt
bar. Refer to section 4.2.4.1 PR MECHA ASY, p. 149.
3. Release the TPE sensor cable from the two cable clamps on the
bottom rear of the printer.
4. Disconnect the TPE sensor cable from the SENSOR BOARD UNIT
(CNTPES: 3 pins), and pull the TPE sensor cable outside the printer
mechanism through the lower hole in the SIDE FRAME, LEFT.
5. Release the TPE sensor cable from the cable clamp on the SIDE
FRAME, LEFT, and feed the TPE sensor cable inside the printer
mechanism through the upper hole in the SIDE FRAME, LEFT.
Disassembly and Assembly
5)-2
TPE sensor
Cable
5)-1
Cable
Clamp
3)
Figure 4-85. TPE HOLDER ASY Removal (1)
Sensors
4)-2
SENSOR BOARD UNIT
4)-1 CNTPES
Revision B
[Front]
[Rear]
201