Adjustment - Epson DFX-9000 Service Manual

Epson DFX 9000
When installing the Carrier holder, replace the cable
protector correctly in the CARRIER UNIT. See
4-27.
When installing the CARD GUIDE ASY, thread the
TOF sensor cables as shown in
Connect the two TOF sensor cables to the PCB
connectors, observing their orientation with reference
to Figure 4-28. Top side: the side covered with an
insulating and reinforcing strip. Bottom side: exposed
metal conductors.
Be sure to perform the following adjustments after
A D J U S T M E N T
R E Q U I R E D
removing or replacing the CARD GUID ASY.
1. Card guide mount position adjustment (p. 227)
2. TOF sensor sensitivity adjustment (p. 235)
Figure 4-27. Cable Cover position during carrier holder reassembly.
Disassembly and Assembly
Figure
Figure 4-28.
CARD GUIDE ASY
Pass cables through
the square holes
Carrier PCB
Figure 4-28. TOF Sensor Cable Reassembly
Revision B
CARD GUIDE ASY
TOF sensor cable
Bottom
side:
exposed
conductor
Top side:
reinforcing
strip
154