Epson DFX 9000
4.2.4.7 LF MOTOR
Do not touch the LF MOTOR immediately after using the
W A R N I N G
printer, or you may burn your hand. Allow the motor to
cool enough to work with it.
1. Remove the
PR MECHA ASY (p. 149)
2. Release the LF MOTOR cable from the three cable clamps on the
bottom rear of the PR MECHA ASY.
3. Match the screw access hole in the Pulley Gear to the screw location
for the LF MOTOR. Remove the two C.P. (S-P1) 4 × 10 screws that
secure the LF MOTOR to the SIDE FRAME, LEFT, and remove the
LF MOTOR.
Disassembly and Assembly
Pulley gear
LF MOTOR
Figure 4-40. LF MOTOR Removal
LF MOTOR
Revision B
Screw access hole
in the pulley gear
3)
3)
161