Basic Functions - Epson DFX-9000 Service Manual

Epson DFX-9000
1.3.1.4 Buzzer
This printer has a buzzer to audibly indicate its status as shown in the
table below:
The symbols used in the table below represent the following:
"•" Short Beep: Buzzer sounds for 1/10th sec. (100 ms) and the
interval is 1/10th sec. (100 ms)
"–" Long Beep: Buzzer sounds for 1/2 sec. (500 ms) and the
interval is 1/10th sec. (100 ms)
Table 1-34. Buzzer Status
Printer status
Paper out error
Cover open error
Incomplete changing
paper
Paper jam
Ribbon jam
Ink ribbon out
Fatal error
Product Description
Beep sounds
• • •
• • •
• • •
• • •
• • •
• • •
– – – – –

1.3.2 Basic functions

Pause
This stops or resumes printing.
When an incomplete paper change occurs, push this button to go to the
next step.
When Tear Off is pressed, and the optional Perforation Cutter is not
installed, the printer advances the paper to the tear off position and
pauses. Press Pause after you have torn off the form to return the paper
to the normal printing (Top of Form) position.
Micro Feed
Adjusts the paper position for Top of Form and Tear Off. The [Micro
Feed ] button advances the paper forward by 0.118 mm (1/216 inch),
and the [Micro Feed ] button advances the paper backwards by
0.118mm (1/216 inch).
The TOF (just after loading) adjustment range is 4.2 to 33.9 mm. The
default setting is 8.5 mm (Default). The buzzer sounds at the minimum,
default, and maximum positions.
The Tear off adjustment range is -25.4 to 25.4 mm, and the default is 0.0
mm. The buzzer sounds at the minimum, default, and maximum
positions.
LF/FF Load
Immediately after loading paper in the selected push tractor, press this
button to load continuous paper into the printer mechanism.
Pressing this button once executes a line feed.
Holding this button down for one second executes a form feed.
Operations
Revision B
44