Epson DFX-9000 Service Manual page 246

Epson DFX 9000
Only the Dummy-Head part of the APG GAUGE JIG is
C H E C K
P O I N T
used for this adjustment.
Adjustment
Adjustment Procedure
1. Open the Top Cover and remove the Ribbon Cartridge and PRINT
HEAD.
2. Install the Dummy-Head part of the APG Gauge Jig, and the APG
PT Jig, in place of the print head on the CARRIER UNIT, as shown
in the figure below.
APG PT JIG
When installing APG PT JIG on the printer, be careful with
C A U T I O N
its front/back orientation. The correct orientation is
indicated by a label attached to the jig.
3. Install the Ribbon Cartridge.
4. Close the top cover and turn the printer ON.
5. Set a single sheet of 64 g/m
press [Load] to feed the paper into the mechanism.
Software adjustment
Figure 5-21. Installing the Jigs
2
(17 lb) paper on the front tractor, and
Revision B
Dummy-Head
239