Epson DFX-9000 Service Manual page 167

Epson DFX 9000
4. Remove the C.B.S. 3 × 6 screw that secures the left end of the CES
SCALE to the inside of the SIDE FRAME, LEFT, and slowly pull
the CES SCALE out from the CES sensor on the bottom of the
CARRIER UNIT.
Attach the left end of the CES SCALE to the inside of
the SIDE FRAME, LEFT with the
interior of the printer, as shown in
Make sure that the CES SCALE passes through the slit
in the CES sensor.
Match the positioning dowel on the SIDE FRAME,
LEFT with the positioning hole of the CES SCALE.
When placing the CES SCALE inside the CES sensor, take
C A U T I O N
care not to bend or damage the CES SCALE.
Disassembly and Assembly
mark facing the
Figure 4-38.
CES SCALE
Reassembly
mark
Dowel
Figure 4-38. CES SCALE Removal (2)
4)-2
CES sensor
Figure 4-39. CES SCALE Removal (3)
Revision B
4)-1
CES SCALE
CARRIER UNIT
160