Epson DFX 9000
Printing-related failure
Some dots are missing, or unnecessary dots are printed.
(NOTE: If the printed characters are uneven on their upper or
lower edges, refer to
Page
117.)
The printout is spaced incorrectly.
Troubleshooting
Troubleshooting procedure
Perform the following, checking for functionality after each step.
1. Clean or Replace the
CES SCALE
2. Check that the CARRIER CABLE UNIT is correctly connected to the ROM
BOARD and the PRINT HEAD.
3. Replace the
CARRIER CABLE UNIT
4. Replace the
PRINT HEAD
5. Replace the
ROM BOARD
1. Check that the APTC adjustment operates normally, and that the paper thickness
adjustment is properly set.
2. Perform the
Bi-D adjustment
3. Clean and lubricate the STAY SHAFT
4. Clean or replace the
CES SCALE
5. Check the
CR drive belt (SP BELT) tension adjustment
6. Replace the
SP BELT
(p.158).
7. Replace the
SP MOTOR ASY
8. Replace the
ROM BOARD
Troubleshooting
(p.159).
(p.189).
(p.152).
(p.137).
(p.250).
(Carrier oil pads
(p.267).
(p.159).
(p.220).
(p.156).
(p.137).
Revision B
116