Epson DFX-9000 Service Manual page 164

Epson DFX 9000
8. Tilt the rear of the SP MOTOR ASY to the right, and lift the Tension
pulley to remove the SP MOTOR ASY together with the SP BELT.
When you remove the Tension pulley, be careful not to
C A U T I O N
lose the washer on the inner shaft. It comes off easily.
9. Remove the four C.P. (S-P1) 4 × 10 screws that secure the SP
MOTOR, Motor base, and Motor bracket, and remove the SP
MOTOR.
Be sure to perform the following adjustments after
A D J U S T M E N T
R E Q U I R E D
replacing the SP MOTOR.
1. CR Drive Belt Tension Adjustment
2. Bi-D Adjustment
Disassembly and Assembly
8)-2
Tension pulley
Figure 4-34. SP MOTOR ASY Removal (3)
SP BELT
9)
9)
9)
9)
Figure 4-35. SP MOTOR ASY Removal (4)
SP MOTOR ASY
8)-1
7)
SP BELT
Motor base
Motor bracket
Revision B
7)
SP MOTOR ASY
SP MOTOR ASY
157